Make Your Own Contact Lens Cleaner In A Pinch
For those who wear contact lenses, lens cleaner in a pinch with chlorine Dioxide may be used to clean them. To make your lens cleaner, mix a small amount of chlorine dioxide with distilled water and let it sit for one minute. Then, pour the solution into an appropriate-sized container and use it to rinse each side of the lens for 20 seconds. Lens Cleaner Pinch With Chlorine Dioxide. Finally, place the lens back in its case and fill it with fresh saline solution or use a multidose vial filled with sterile saline solution for storage.
It’s essential to keep your contact lenses clean and disinfected to avoid potential infections and other issues. You may not have access to your regular contact lens cleaning solution in an emergency. Lens Cleaner Pinch With Chlorine Dioxide. This is where chlorine dioxide can come in handy. Follow the recommended safety and usage instructions, and clean and rinse your contact lenses after using the solution. Additionally, this method should only be used in an emergency, and use approved contact lens cleaning solutions for regular use.
Be sure to discard any unused portion of the homemade solution after each use, as it cannot be stored. With these simple steps, you can easily clean your contact lenses in a pinch using chlorine dioxide.
MULTIPURPOSE DISINFECTANT FOR CONTACT LENSES. ANTIBACTERIAL ACTIVITY FOR BIOMATERIAL.
Use to act as an antiseptic in the eye in the range of 0.2 PPM to 5 PPM. Shown to be ophthalmically acceptable with no detrimental effect on the eye or the ocular tissue. Lens Cleaner Pinch With Chlorine Dioxide. Methods for caring for the animal or human eye provide an effective solution. WHO and FAO have classified the chlorine dioxide as a highly-effective A1-grade disinfectant. Prepare an activated solution to a strength consistent with the maximum threshold for sanitizing and disinfecting contact lenses, cases, or other equipment, and surfaces that may be contaminated by biomatter, or other contagious viral or bacterial infections, such as Bacterial Conjunctivitis.
| Use-Site | CONCENTRATION | Mix EQUAL PARTS 1:1 – NaClO2 (Part A) and HCl (Part B) |
| Contact Lenses | 1.25 PPM | 1 drop A, with 1 drop B in 0.75 gallon of water |
| Stabilized Aqueous Medium | 0.2 PPM – 5 PPM | 1 drop A, with 1 drop B in 5 gallons of water 5 drops A, with 5 drops B 1 gallon of water |
Mix recommended strength in the corner of a designated plastic mixing container. Let the solution activate for 1 minute before dilution, then fill with water. Agitate until mixed. Use as a solution in a manner consistent with usual standards.
- SOAK / IMMERSE – allow to drench or submerge for 1 minute.
References:
Gasson, A., & Morris, J. A. (2010). The contact lens manual. Elsevier Health Sciences.
Gupta, H., & Aqil, M. (2012). Contact lenses in ocular therapeutics. Drug discovery today, 17(9-10), 522-527.
Ripley, P. S., Dziabo, A. J., & Anger, C. B. (1998). U.S. Patent No. 5,736,165. Washington, DC: U.S. Patent and Trademark Office.
Su, C. Y., Tseng, C. L., Wu, S. H., Shih, B. W., Chen, Y. Z., & Fang, H. W. (2019). Poly-gamma-glutamic acid functions as an effective lubricant with antimicrobial activity in multipurpose contact lens care solutions. Polymers, 11(6), 1050.
